Description
Plastic Primer Aerosol spray 400 ml
Plastic Primer Aerosol spray 400 ml for the purpose of increasing the adhesion of subsequent top coats to a wide range of plastic parts and components, including bumpers plastic interiors and components.
Colour
yellow transparent
Products and Additive
Plas primer
Coverage
A coverage of 4 – 6 m sq/ltr.
Flash point
above 21°c ( Flammable)
Application Substrates
Plas primer is recommended to be applied over ;
– Fibral or Scotchbrite decreased and clean plastic
– Well sanded original finishes
Surface preparation
Degreaser with Aquawipe Degreaser.
Wet sand with AQUAWIPE using a Fibral hand pad.
Heavy coats applied wet on wet should be avoided .
Normal coats should be applied allowing flash off times of 5 mins between coats.
Mixing Instructions
R.F.U
Spraying viscosity
11-15 secs Din cup 4 at 10°c (20 -23 secs BSB4 cup)
Spraygun fluid tip and working pressure
tip pressure
Gravity feed Spraygun 1.5mm 2-4 bar
(30-60 psi)
Suction feed Spraygun 1.8mm 2-4 bar
(30-60 psi)
Application process
Apply two coats allowing 5 mins flash -off time between coats .
Then apply with in 30 mins your desired topcoat.
2k primers
Mirrorbase
Mirrorcryl
Plasticoat topcoat
Drying
at 20 ° C
Dust free 10 – 15 mins
Flatting
Wet flat with p600 – p800 paper
Basecoat with p800 – p1000 paper
Storage
12 months for unopened cans.
Ambient temperature for application is above 10°c low humidity /dry conditions.
Recoatability
Within 30 mins of application ,apply further coats if time is extended beyond this.
Cleaning solvent
Mirror low cost thinner
Points of Note