Washfiller Etch Primer Filler (Metal Aluminum And Plastic Primer) 2 Litre Pack

£47.50

Description
Tough two pack etch primer filler ,it possesses good Rust inhibiting properties and absolutely superb adhesion, good application and flatting properties, non chromate. T

Out of stock

Email
Compare

Description

Washfiller Etch Primer Filler (Metal Aluminum And Plastic Primer) 2 Litre Pack
Description
Tough two pack etch primer filler ,it possesses good Rust inhibiting properties and absolutely superb adhesion, good application and flatting properties, non chromate. This is a exceptional primer for aluminium , metal and wood , and is the bonding primer on plastic products. After coating the product can be left outside for upto 6 months prior to topcoat.
Colour Light beige
Products and Additive
106.001 – Washfiller -Pigmented and special resin blends.
108.001 – Activator -Phosphoric acid.
Coverage
A coverage of 8-9m sq/ltr. Of base paint Flash point below 20°c (Highly Flammable)
Application Substrates Washfiller etch is recommended to be applied over ;
– Bare steel – Aluminium – Galvanised metal – G R P (Glass reinforced plastic) – Rigid Plastic bumpers – T P A Thermoplastic acrylic : * Please take note! – Polyester fillers and stoppers after flatting cellulose
Surface preparation
Degreaser with Quick wipe Degreaser.
Dry sand with p180-p240 grade paper. Wet sand with p400-p600 grade paper. * Washfiller etch can be applied over TPA but cellulose topcoats are not recommended as there may be a reaction with TPA if heavy wet coats of colour are applied .Care should be taken with Mirrorcryl TWO pack Acrylic solid colours ,and with Mirrorbase clear over base systems over TPA. Heavy coats applied wet on wet should be avoided . Normal coats should be applied allowing flash off times of 10 mins between coats.
Mixing Instructions
100 parts Washfiller etch -100 parts Washfiller etch activator.
Spraying viscosity 18 – 20 secs Din cup 4 at 20°c. (20 -23 secs BSB4 cup) Spraygun fluid tip and working pressure tip pressure Gravity feed Spraygun 1.5mm 2-4 bar (30-60 psi) Suction feed Spraygun 1.8mm 2-4 bar (30-60 psi)
Application process By Spray
Apply one mist coat followed by 2/3 single coats allowing 10 mins flash -off time between coats . Further single coats can be applied to give greater build for filling deeper sanding marks.
By Brush Application by brush is possible with a 4- primer to 1- Activator mixing ratio, the result will not have as greater adhesion as by spray as the activator gives the acid etch quality.
Drying at 20 Degrees C Dust free 10 – 15 mins Wet flattable 30 – 40 mins Recoatable 40 – 60 mins Flatting Wet flat with p600 – p800 paper Basecoat with p800 – p1000 paper Storage 12 months for unopened cans. Ambient temperature for application is above 10°c. low humidity /dry conditions. Recoatability With nitrocellulose stoppers (not with polyester type fillers and stoppers) Washfiller etch can be over coated with all standard refinishing systems. Cleaning solvent Mirror low cost thinner

Additional information

Weight 2 kg
Dimensions 300 × 130 × 120 mm